PLEASE need some 411

[BillsBlast]

got rebuild done had drain crankcase to adjust clutch and little cylinder about a 1/2 in long and 1/4 wide fell out of drain hole thought it was set pin got it back together when u go to take off it stops and stalls

 

[scotj77]

I would assume that was a needle bearing.

 

[scotj77]

can you post a picture of it?

 

[hudack]

some pictures would be nice

 

[BillsBlast]

no but it looks like alittle cylinder dont if its a set pin from me putting the cases back together or if its from tranny bc some thing wrong run great try to go about sends u over bars

 

[Awk08]

sounds likie one of the pins from the end of the shift forks ????
isnt there some pieces on them similar to what he is describing ????
is it solid or hollow

 

[brandoz28]

i agree, that's about all i can think of it being too. that would be a very odd failure

 

[BillsBlast]

its soild stabor was here when got running he thought it had something to do with shift fork

 

[stabor1122]

Dude I just pulled out those spare tranny parts I have and it is most definately out of one of the shift forks. Its the pin that runs in the shift drum to select the gears. Sucks but you will have to split that bottom end again and I will get those tranny parts over to you. Not sure how that would have come out but I would pull out ALL of your tranny gears and put these other ones in there.

 

[BillsBlast]

can i put them all as one unit

 

[stabor1122]

All of the shafts are still assembled but they are not one unit. Will have to just pull them one at a time to replace them.

 

[BillsBlast]

is this somthing i can do myself sounds and LOOKS hard wont they fall apart then im screwed right???

 

[stabor1122]

They shouldn't fall apart. I think they are press fitted. I can give you a hand on Saturday.