could I switch these gears are not?
- Thread starter bubba813
- Start date
& i was wondering if i could take the gears from a 2006 blaster in put in to my 1995 blaster would they be the same? & would they Fit?
they should be the same, the engine on all yrs were mostly the same, aside from some small differences.
yep it will work fine the only diffarence from the 1995 and the 2006 was dat the 1995 had the pipes sticking out the front on the right side (because the bottom end is off a dt200 witch the blaster engine is beaced on)
yes roadkill you are correct. You can use dt200 gears and blaster gears to get the perfect gearing you want by swapping each gear out.
sorry to threadjack but if i got a dt200 1st gear i could switch it with mine to have a taller first gear?
Macdizzy mentions the transmission between the two being totally compatible and how if it was needed that bad you could swap gears between the too and get the almost perfect gear ratio and shifts. The dt200 was a dirtbike so the gearing is a little taller i think.
