stator spec question

[blaster240R]

:-/ hey guys i think i'm having an issue with my stator. i have a 98 blaster so my stator only has 4 wires black, black/red, white/red, and yellow/red. if someone has a clymer manual on page 245 table 2 is the ignition system test. everything seems to test good except for the pulser coil (white/red). the resistance spec says its 72-108 ohms. mine tested at 19.8 ohms. not within the limits specified. i would appreciate it if someone could test the same wire (white/red) pulser coil and let me know what you get. i just want to make sure mine is wrong and not a misprint in the manual. thanks alot. Ryan

 

[blaster240R]

bump bump need a little help guys.

 

[j_blaster]

My manual (not a clymer, but the Yamaha Blaster Service manual that can be gotten online (or PM) says that this resistance should read 16-24 ohms. Mine (2001) reads right at 20 ohms, so I think your coil is good and your book is bad.

 

[blaster240R]

thanks you deff. might be right. thats why i was questioning it. the help if deff. worth some rep points. thank you. Ryan