G gearhead04 Member Jun 8, 2009 1,016 9 43 Dec 16, 2009 #1 I have the flywheel, stator plate, cylinder, head, and clutch off. Do the 3 screws that are under the timing plate have to come out to split the cases? I have the 6 or 7 screws out that are outside the case.
I have the flywheel, stator plate, cylinder, head, and clutch off. Do the 3 screws that are under the timing plate have to come out to split the cases? I have the 6 or 7 screws out that are outside the case.
blasterfreek30 Member Jan 27, 2008 9,634 129 94 north nj Dec 16, 2009 #2 yeppers they do..........they are long philips head screws
yamaha blaster New Member Jun 15, 2008 1,193 5 0 Michigan Dec 16, 2009 #3 Yes the do. 15151515151515151
G gearhead04 Member Jun 8, 2009 1,016 9 43 Dec 16, 2009 #4 ok. thanks. I'd assume they have locktite on them, should I heat up the case a little bit to assist them in coming out??
ok. thanks. I'd assume they have locktite on them, should I heat up the case a little bit to assist them in coming out??
Tim Lutz New Member Aug 20, 2009 167 5 0 Columbus OHIO Dec 17, 2009 #5 If you heat the cases up it will probably make them tighter. Use a hand impact with the proper size bit and a hammer.
If you heat the cases up it will probably make them tighter. Use a hand impact with the proper size bit and a hammer.
S shee4speed New Member Dec 13, 2009 22 0 0 Az. Dec 17, 2009 #6 make sure you mark the location as of where each screw came from.And do not strip them out.