i need a answer

PGH PA 2 STROKE

New Member
Jun 12, 2010
213
2
0
Linkcoln Place
ok again i sunk my blaster up to the bars again
in water so i get home get the water out .... so when i
kicked it . it fired right up for a sec then stalled
there was no key in it so fine i put the key in it wont
start so i took the key switch out push start it .it trys to start
runs like poop for a sec and stalls . i push it up in my drive way,
take my air box lid off its filled water .clean it .... runs no better
,i checked the spark berley any so i take the coil off my
RM125 blaster ,the spark is not better , check any water any were
its out , whats going on here???? its a electrical problem
it used to have really good spark ?????? whats problem

:-/:-/
 
have you checked to see if the there is any water in the stator cover? make sure the water is out of the cylinder and such and let her air out for a day or two
 
my buddy swamped his kx125, we had ro pull the pipe, it was full at the bend, and the bottom end was filled also, we stood it up on its front tire and kicked it a few times amazed at how much came out, left the pipe , intake, stator and clutch covers off overnite with a turbo heater blowing warm air on it, reassembled the next evening and got it fired
 
well thanks for the reply's but i put a 1993 rm125 stator and wiring on it , it work really
really well gave more top and botom end but i would still like to know what happen