I have a dyno port stroker exhaust
A 35 mm pwk airstriker(on its way not set up only ordered #6 slide)
Cfm air box with recommended filter size ( I think 6in)
Going back to stock reed cage till I get v4s ( getting rid of rad valve )
Port and polish by KOR
Head milled by KOR (set up to run 180psi)
4 mm stroker crank
Ridding at sea level ( gonna ride threw winter around 30 degrees)
Gonna be trail mainly
Any help on where to start on all jetting and the needle would be great thank you
A 35 mm pwk airstriker(on its way not set up only ordered #6 slide)
Cfm air box with recommended filter size ( I think 6in)
Going back to stock reed cage till I get v4s ( getting rid of rad valve )
Port and polish by KOR
Head milled by KOR (set up to run 180psi)
4 mm stroker crank
Ridding at sea level ( gonna ride threw winter around 30 degrees)
Gonna be trail mainly
Any help on where to start on all jetting and the needle would be great thank you