Search results

  1. 8

    leak!!!

    Just wonderinghow big of a job it would be to change that seal behind the kicker...I think its leaking trans oil all over.
  2. 8

    welding swing arm

    I have a crack in my swing arm on the ccross member above carrier . can it be welded?
  3. 8

    front end build

    Looking to rebuild my front end of my 2000 blaster and convert into hydro. What's the best route and/or alternative. Thanks
  4. 8

    Swing arm

    my stock swing arm is cracked so looking to get an extended one but don't know how much extension to go with. Can anybody help? And was wondering what else I would have to change or will it just swap right out?
  5. 8

    New chain

    hey does anybody know if a chain can stretch? I pulled the carrier all the way back and my chain is still really loose. Does anybody know of any good chains u recommend for just a stock swing arm. Do I have to change both sprockets as well??
  6. 8

    Rust

    Anyone got any tips on an easy way to clean rust off frame and axle? Just wanna shine her up a little without having to remove everything
  7. 8

    Best way to clean

    I'm trying to get it as clean as possible but there's some greasy mud in some spots hard to reach. Anything I can spray on and pressure wash off? Or what's the best way to clean the motor, carb, grease.... Without damaging anything.
  8. 8

    Rear brakes

    My rear brakes dont stop me as they should! Possibly in need of new brake pads? If so what kind of pads should I buy I have a 2000 blaster.
  9. 8

    A arm ball joints

    I just recently bought this blaster and had to replace front spindles back to stock and was wondering how far down should the upper ball joints sit in the pinch bolt? Down to the groove in the joint or up above a little?
  10. 8

    Rear axle help

    just wondering if anyone could help me find out what type of axle this is and if it's extended. I was told it was aftermarket and extended but don't know what it came from. I have a 2000 blaster200 Thanks
  11. 8

    2000 blaster front hub/spindle/brakes

    I just bought this blaster about a week ago and trying to figure out what front hub/spindle/brakes this is because I'm trying to change a arms but the 2000 blaster a arms don't fit because of no pinch bolt on the spindle. Does anyone have any ideas???!!!
Top Bottom
Back