Recent content by BlasterSPL

Thanks for the replys got it apart and ended up having a bad bearing on the crank..Replacing everything inside that needs replacing..Thanks again Kurt

Whats the best way splitting the case on an 01 Blaster? Im rebuilding from the bottom up and heard to use a Brass hammer to split the case..I just dont want to stress the cases like I hear about using a hammer..Also do you need a clutch tool to remove the clutch basket? I just received my...

Ya good luck i dont buy anything off ebay anymore..Been ripped off 3 times and you try to give people benefit of the doubt but you still get sh*t on..Anyways just get one from Yamaha..I know there expensive but in the long run you will not regret it..Also that wire on the stator is insulated so...

You have to pull the flywheel to check if its clean..You cant tell without pulling apart..Use a test light on the Black and red striped wire..This is your ignition wire..On mine it ended up being corroded flywheel and used steel wool to clean up..I also had to replace the woodruff key was...

I just did my rear brakes and now they work great..You guys really saved me a lot of time and money with the "How To sections" that have been posted..Now I have all the kids with 4 wheelers bringing them over to work on them cause they see how well mine runs thanks to all of you..Appreciate all...

If everything works right you shouldnt have to kick over so much..It should fire within 2 to 3 kicks cold..When I checked my stator with a test LED was very bright but took flywheel off and had to clean up the flywheel was just making contact sometimes and the bike would fire and once running...

Theres many topics on making it faster..Just read up in the DIY section..LOLKurt

Also If you havent removed the TORS do it..Theres a how to and trust me from what everybody else says its necessary especially if your wife is going to ride it..Kurt

Mine was the sameway hard to start..Did you check your stator in the case? Mine ended up being acorroded flywheel..I had to purchase a flywheel puller and used a 17mm impact and got inside and was covered with white powder..I cleaned it up with steel wool but while I was in there I installed a...

Yep shorty cable is the way to go..Nice right up!!Kurt

Ya I still have the stock 13/40..Just got my 14 tooth front sprocket and getting ready to slap it on..I live in Florida and ride in a lot of sugar sand..I currently run 18 rear holeshots but thinking of going to a 20" rear just for a little xtra clearance..The timing advance is a must do but it...

Where are you from?

It depends if its stock or if its modified..Maybe 50 mph plus stock..Kurt

Thanks for the DIY I just did mine and noticed a much snappier throttle and indrease of power..Hell Ya!!

Actually I wouldnt be pissed cause thats one bad Blaster..LOL Kurt