very nice looking swinger there. If you make a +3 and would ike it tested for extreme MX let me know?
I would have rotated the flame carrier just a bit more back so its more visible but not hatin because thats some clean work and the welds are pretty damn sweet looking too!
What's with the shock mount? Only way for good "placement"? What shock you using?
Are you doing a linkage set up? Looks awesome.
are you going to sell your old +4 ?
I may be using it for parts on the next swingarm!
hate to say it but what if u put the axle in a lathe? and turned the back of the hub stopper thing back 3/16???
ehhhh, so what if the axle is offset 3/16", throw 3/16" of washers behind the short side wheel hub to space it out even
if it bothers you. but it won't effect the ride at all.
i put the spacers in the wrong order on my g-force axle and was offset 1/2" to one side, was like that for 2 seasons and nobody knew but me and my tape measure.
as long as it's aligned straight, it didn't make one bit of difference in the ride. she rolls straight down the hard road
it's actually put together like that again now, but i have since figured out the one spacer goes on the outside of the brake hub and will be put like that when i install my new rad carrier.
Now I think im just going to run it as is until i get a new axle next year.