welp cause for my rebuild

[dirtyblaster]

blew the top piece of my head gasket

the nasty ass leak it caused

te weird thing is that ron has had almost the exact same thing happening to him and i even had some nasty noise happening while it was running

 

[dirtyblaster]

ohh my motor had 190 compression when it has the last rebuild

 

[blasterfreek30]

that looks like the head bolt might have been lose on that side, cooked the gasket pretty bad

 

[dirtyblaster]

it was a lil loose from the vibrations so yeah

 

[245stroker]

doesn't look too bad, I'd say you got lucky and caught it just in time

 

[dirtyblaster]

u think i should rebuild it or just get a new gasket?

 

[blasterman87]

i would get a new gasket and do a comp check, 190 is really high no wonder it blew the gasket

 

[245stroker]

Since its apart, I'd do it right and rebuild it. I believe in doing it once and doing it right.

 

[blasterman87]

yeah, good point 245, but for me it would depend on the compression and condition of the cylinder walls if its all good i would run it, as long as its not knocking or anything

 

[245stroker]

yeah, good point 245, but for me it would depend on the compression and condition of the cylinder walls if its all good i would run it, as long as its not knocking or anything

Yeah, thats what I meant. Check the cylinder for wear and make sure its round. If it is, I'd at least hone the cylinder and throw a set of rings in it, since its a part.

 

[blasterrider119]

ya and clean up the piston abit