Spark Plug Boot

[nightsterman]

Ok so i have gone through three boots in the 2 months Ive owed a Blaster so i decided it was time for something different. I had an extra plug wire laying around the garage so i pulled the boot and uncrimped the connector. i recrimped the connector on the blaster coil wire (be careful uncripming and crimping so you dont break it). i added a little solder and slid the boot over. Ive been riding for a few weeks now without a single problem. I:I I:I

 

[brandoz28]

good job. i just went to the dealer and got an NGK boot for a snowmobile, works well so far

 

[zachd242]

i need a boot i guess cause my wire has been cut like to short to reach the spark plug so i might need a new spark plug wire and cap!!

 

[B-1]

if the boot is good u can reuse it just get a new wire

 

[astepup]

My plug wire is also getting short. How hard is it to replace the plug wire? Can the wire be twisted out of the coil, just like it does from the cap, or is it a little more involved than that. Or once the wire is too short does the entire coil need to be replaced.

 

[pwgsx]

ngk makes a spark plug wire splice kit, works well on my bike