removing warning decals?

[vspec]

Does anyone know a good way to do this?

Sadly I have a 97 and my warning decals are not just riveted on plates like on the 99 - 06.

I've been trying to remove them with a razor blade but thats going to take hours.

 

[Painthehouse]

boiling water and a paintscraper?

 

[vspec]

that won't warp the plastics?

 

[EvilElvis]

heat gun and a credit card or serving spoon or a propane torch .....just dont get to close with either

 

[Quadrider10]

Does anyone know a good way to do this?

Sadly I have a 97 and my warning decals are not just riveted on plates like on the 99 - 06.

I've been trying to remove them with a razor blade but thats going to take hours.

I've used plyers and just pulled them off I the bottom o the fenders, and they came rite out. To fill te holes, I got mixable epoxy, and I stuffed that in all the holes. Than I waited for it to dry, and sanded the top of the fender where the eloxy is only so it was flush with the plastic. Tha. I just mixed spray paint and painted it on. Took a bit of time, but from a distance u can't notice it as long as u got the rite mix of paint. Also don't try to mix paint with the epoxy. It will turn to putty and never dry. I tried lol

 

[vspec]

heat gun and a credit card or serving spoon or a propane torch .....just dont get to close with either

Thanks, I don't have a heat gun but a hair dryer worked.

+rep