Removing oil seals on crank help.

[Davo]

Anyone have any tips for removing the clutch side (right) crank oil seal?

The stator side is a breeze. I am having trouble coming up with a good method to remove it from the outside on the gear side. I have a extra case to experiment on.

 

[Fast6hand]

Take a drywall screw and screw it in a bit. Not to much, you don't want to hit the bearing. Take a pair of pliers and pull. Install new seal with seal grease if available. A leak test is always good before and after as well. May check to see if collar is sealing good.

 

[Davo]

Its the thinner brown one. I am having trouble getting a bit to sink into it on my test case.

 

[Fast6hand]

Maybe even try a pick tool.

 

[Blaner]

Whatever you do, just be careful, you dont want to scratch the sealing face

 

[Larry's Shee]

Pay attention to which way it goes in. Clean Cshaft and inside of collar. Smear a little 3bond, yamabond inside collar before installation.