HAHA thanks for the heads up I:INot frying the top end=saving you a couple hundred bucks
Yeah i blipped the throttle and it hung up then settled back down it was still idling like normal but it would just hang after i would blip it.Important thing is not to put more than 6-7 pounds of pressure in it. When idle was hanging did you "blip" the throttle and it still was hanging? Have you checked that there are no kinks/sharp bends in cable? try lubing cable? (good maintenace anyhow)
yeah i didn't find any zip ties but it is clustered in with a bunch of cables down the steering column hole. I will try to free it up tomorrowDid you make sure there r no zip ties on the throttle cable and that its free from the thumb throttle to the carb?
Could it be an improper block off plate installation? because like i said it started right when i drained all the fluid and i took off that plate could that be the air leak?My money is on air leek since the cable seems to be ok, but like larry said, the cable could need lubed
Could it be an improper block off plate installation? because like i said it started right when i drained all the fluid and i took off that plate could that be the air leak?