hey everyone. i recently got a blaster from a friend and it has not been started in awhile. i got it home and went to start it and it goes full throttle like its gunna blow the motor and then shuts off. in order to get it started i had to pull the choke all the way out. when i put the choke back in dies. This is what i have done so far...
1. pulled carb of and semi cleaned it. mostly sprayed carb clean inside and wiped clean. and then re installed.
2. removed tors
3. removed throttle cable from handle bar to make sure there was no binding
4. ive tried turning the fuel switch both ways when running at those high rpms
a few minutes ago i got it to start and run for even longer with out dieing. it started with more of a mellow rpm and then went to high rpm. i tried turning fuel adjuster screw near tank but did not help. i then went to hit the off switch and that did nothing so i finally pushed the choke in and it died. i did try to move the throttle cable but i felt no response. got any ideas?
1. pulled carb of and semi cleaned it. mostly sprayed carb clean inside and wiped clean. and then re installed.
2. removed tors
3. removed throttle cable from handle bar to make sure there was no binding
4. ive tried turning the fuel switch both ways when running at those high rpms
a few minutes ago i got it to start and run for even longer with out dieing. it started with more of a mellow rpm and then went to high rpm. i tried turning fuel adjuster screw near tank but did not help. i then went to hit the off switch and that did nothing so i finally pushed the choke in and it died. i did try to move the throttle cable but i felt no response. got any ideas?