Hows it look?

[88' blaster]

i got some pics with my motor when i took the head off. what do u guys think?

 

[wheresthericego]

looks blurry...

 

[88' blaster]

looks blurry...

its a cell phone pic so bare with me

 

[scotj77]

looks fine to me. might be just a touch rich. unless you put around a lot. then that's normal.

 

[Awk08]

i see no obvious damage, but who failed to clean the gasket surface on the cylinder and head on the last rebuild, they look horribly dirty

 

[88' blaster]

i see no obvious damage, but who failed to clean the gasket surface on the cylinder and head on the last rebuild, they look horribly dirty

the shop. there will NEVER touch anything of mine again

 

[NEONNIGHT34609]

agree it also looks like they might have used a sealer on it too ? :-/B)

i see no obvious damage, but who failed to clean the gasket surface on the cylinder and head on the last rebuild, they look horribly dirty

 

[99LRDblaster]

Looks like an engine.

 

[MXsandracer]

looks like... your head gasket was leaking ? either that or you tried to clean some carbon off that piston which is why its wet around the sleeve??

also, i would look in through the exhaust port and see if you have any blow-by on the front side since you can see in. i think thats wat the last pic was supposed to be?

 

[specialized7]

looks good to me. Clean that piston off

 

[hudack]

looks happy to me

 

[88' blaster]

i should post up a vid for you. the piston had quite a bit of play

 

[hudack]

whats the pistion to wall clearance

 

[88' blaster]

whats the pistion to wall clearance

idk all i know is when i bring it all the way to the top it wiggles alot. i was told this is bad