found out y my clutch was slipping

[06blasterboy06]

i order a new clutch by tusk witch was great i took off the bolts and springs and now im taking the clutch plates off and i found a broken plateI:I

 

[sicivicdude]

That'll do it every time.

Just make sure you soak those new plates in transmission lube (whatever you're going to use) before installation and then adjust the clutch according to the manual.

 

[06blasterboy06]

i put in all ready yea i did lube them up easy job

 

[sheeblast]

pic of the broken fiber or you are lying.

 

[Blasterb0y794]

i put in all ready yea i did lube them up easy job

Did you soak them in oil, or did you just wet the plates and put them in?

 

[06blasterboy06]

ok wait will do that now

 

[06blasterboy06]

just wet them y

 

[sheeblast]

you want to soak the fiber in the fluid you are going to run atleast overnight. should be 24hours. then put them in.

 

[06blasterboy06]

 

[06blasterboy06]

[/IMG]

 

[sheeblast]

way to ninja edit that. but ya that is bad. i had a brand new clutch in my zilla just fall apart on me. then another fiber crack. it sucks.

 

[06blasterboy06]

[/IMG]

 

[06blasterboy06]

but i got the blaster like this i didnt test drive r nothing 1 ihad a rev problem i fixexed that then the clutch

 

[sheeblast]

it just happens. but i would suggest taking your new clutch out and soaking it in atf type f over night.

 

[06blasterboy06]

im going to it was easy and i hooked up the trail tech almost done with my paint just puting it all back

 

[heyketz]

could be a problem lol

 

[Blasterb0y794]

just wet them y

You better take that clutch back off and ATLEAST let it soak for 24 hours. When i get new clutches i like to wait 48 hours...

 

[scotj77]

mines been soakin for about a month. lol

 

[Blasterb0y794]

mines been soakin for about a month. lol

The longer the better! I:I

 

[06blasterboy06]

just asking y do u need them to soak