Been having weird clutch issues, followed directions for adjusting it and it's been mostly okay, didn't seem to disengage the clutch quite as hard as I would like but enough that it wouldn't die in gear.
Well now within about 20 actuations of the lever it walks up and pretty much out of the socket, it gets to the point it'll run into the carb and intake and it'll feel really free. If I smack it back down into the hole deeper it engages again.
Is there something meant to hold it down? It's it just worn too far? I've tried bending the clutch cable bracket down as far as possible thinking it's angled up but that does not appear the case. It appears to walk up a little every time I pull and release the clutch lever.
I can build something to kind of capture it and hold it down but I'm trying not to hillbilly this too bad
Well now within about 20 actuations of the lever it walks up and pretty much out of the socket, it gets to the point it'll run into the carb and intake and it'll feel really free. If I smack it back down into the hole deeper it engages again.
Is there something meant to hold it down? It's it just worn too far? I've tried bending the clutch cable bracket down as far as possible thinking it's angled up but that does not appear the case. It appears to walk up a little every time I pull and release the clutch lever.
I can build something to kind of capture it and hold it down but I'm trying not to hillbilly this too bad