So during my rebuild I found out I needed to make an mount for the back master cylinder. I did not realize that they did not just bolt right on until after I did my paint job.
Piss Poor Planning = Piss Poor Performance
Luckily I have a bent 03 frame so I tried to cut out the mount from the frame with Oxy- Acetylene torch.
The following Swiss cheese is the result of that attempt.
Well That did not work so I grabbed a pneumatic grinder and went to work.
This is the result of my first ever attempt at welding a bolt to a bracket
Not pretty, Good thing it only holds the back brakes and not something important ( sarcasm noted).
Maybe my first and last attempt at custom fabrication with a welder.....
Piss Poor Planning = Piss Poor Performance
Luckily I have a bent 03 frame so I tried to cut out the mount from the frame with Oxy- Acetylene torch.
The following Swiss cheese is the result of that attempt.
Well That did not work so I grabbed a pneumatic grinder and went to work.
This is the result of my first ever attempt at welding a bolt to a bracket
Not pretty, Good thing it only holds the back brakes and not something important ( sarcasm noted).
Maybe my first and last attempt at custom fabrication with a welder.....