03 Blasty will only Idle with choke on

[swsmith72]

HELP... HELP...HELP...
I removed the dynojet kit, and returned to stock, I bought and installed a rebuild kit, I cleaned it well while it was disassembled and changed main jet to a 260 . After all that It still will not idle... BUT

If choke is out it will idle. Here's the details

I am located in Central Florida at sea level @ 85-95 degrees

1. New top end and gaskets
2. FMF Fatty w/ PowerCore 2 silencer
3. UNI air filter
4. Stock engine w/ boyessen reeds
5. Tors still mounted but disconnected (yellow/Black wire coming from CDI is connected to ground)
6. 260 main, 32.5 pilot, clip in 3rd position on needle, air screw 1 and 1/2 out, airbox lid on but snorkel removed "per FMF's site"
7. Oil injection removed/mixed 32:1
8. Parking brake swich disconnected

I am located in Central Florida at sea level @ 85-95 degrees

While it was running with choke out I sprayed starter fluid aroung intake and it did not rev at all, so no leaks.

 

[L.T.]

have you tride to set the idling with the idle screw (under the seat)

 

[swsmith72]

no effect at all

 

[L.T.]

how much did you turn the idle screw remeber clock wise is to set it higher

have you tride setting your air screw at 2 turns

your tors can also play a roll in this but lets just see if it is not some thing els.

 

[swsmith72]

I ordered 30mm carb from cpw today hopefully this will resolve my issue.

 

[nonpoint86]

you can also try ajusting your throttle cable I just recently had this problem with my blaster not wanting to idle...i just screwed it in a little and it fixed the problem wal ah... i would give it a shot and see what happens