Search results

I ordered new shoes for the front drums I will see if that does it I done have a rear brake caliper for the disk brakes I need to get one though

It started and ran fine for about a hour or 2 then got it on the road and it died had to push it back got a new NKG B8ES spark plug gapped at .028 or so. Did a compression test and it was about 105 or 110 it has nice blue spark and it had some moisture on the spark plug after a few kicks and...

I have a 96 blaster when I go through water and come out the brakes work fairly well for a short time then they will lock one wheel up completely making a loud noise and other times they don't work at all any ideas

i have a 96 blaster rode through a creek then made it about two hundred feet of no more than half throttle then it died. now 2 days later it fired and ran for about 5 minutes or so then died it will fire and start but runs bad and take 4 to 6 kicks to get it too start. bad throttle response...

I have what I believe to be a 2002 blaster and there is 2-3 coats of paint over the vin. I have heard you can take lacquer and remove the paint to view the vin. How affective is this method and is repainting required and how is it applied. Also is there any other method that works well? Thanks...

Yeah

Maybe a little but not to bad

Yes well 3 of the 4 bolts are

My altitude is around 500 feet. So you are saying low compression could cause low speed I also have boyesen power reeds I need to put on

Have a 2002 blaster full pro circuit exhaust 304 pipe Pre mix 32:1 93 octane with Yamalube 310 Main jet Bored .50 over Stock air filter Compression is about 115 Starts second kick. But it will only top out about 40-43 mph Has a exhaust leak because I only have one spring at the header. Could...

What would be a sign my main jet is to small. It has a decent amount of power up until just before half throttle then it kinda Boggs out. The fastest i have had it was 37 miles per hour. That's it.

I have a 02 blaster bored .50 over stock air filter full pro circuit exhaust at a 700 ft elevation going to be around 30 to teens temp wise what would a good start point for jetting.