Search results

Okay first let me describe the problem to the best of my ability then I will tell you guys what I have done to try to fix it. So whenever I ride and I get on the throttle the bottom end punch is there. But, as I continue to push the throttle farther and farther towards 3/4 - full throttle, it...

I recently build a leakdown tester and now all I need is an exhaust blocker if you know what I mean. Where might I be able to find a freeze plug for that will fit the exhaust? And would the size be 1 and 3/8 to 1 and 1/2? Thanks

What should one look at paying for a pair of Works or Elka front shocks used? Of course it depends on the stage, model and what not but I just wanted some opinions on a number that I should shoot for.

So I went to change my chain and sprockets and everything is going swell, except when i try to loosen the two rear axle carrier nuts that you must loosen in order to adjust chain slack they won't budge and I am only rounding off the nuts. They're as soft as butter... Are they a reverse thread?

Am I the only one who thinks the stock pipe pulls pretty hard at times? Because it can scare me in the woods. Or am I just a newbie who has seen nothing yet haha.

Do i need to replace the washer or get a new screw? It's a veryyyyy slow drip and it's not loose nor too tight.

Had exhaust leaking from where the exhaust and engine meet so I took it off and it appears there was no gasket there. There is supposed to be one there right? Also it looks like vibration (Im guessing) indented little rings around the hole there. I did look at the piston and it looks perfect though.

So I decided to strip the paint off of my plastics and after a couple cans of carb cleaner later It went from this: To this! Also, I looked at the serial number and it is a 95 i guess the guy didn't know much about what he had. They only made the purple and yellow for two years...

Are the notches shown on the fiber plates supposed to all line up or something? I don't have them in line as you can see...

So when I got the blaster there was a clutch issue. When you shift into first it would stall/jump. The PO had a clutch kit that he had planned on using to replace it but never did so i figured i would try it. I drained the oil and as you can see it was a milky white. I'm not too sure...

Opened the air box lid and there was nothing there... Should I be scared? Took compression but my tester has a leak in it so it wouldn't stay still for long but it got up over 100 psi. It's a totally stock blaster also. And i noticed that the previous owner had painted a few areas on the frame...

Been on the forum researching for a few months but finally picked up a blaster today. $850 all stock 1998 except for the plastics being painted. Does have a clutch problem though, but the guy had a clutch kit and never got around to fixing it so I'll be able to do so hopefully. Tell me if the...

Are they gonna be having drag races then? It says on the website that they have them the last weekend of every month. Just didn't know if any of you raced there. I wanna go when they're dragging.

If anyone has a stock blaster with no widening done to the front end, could you tell me the width from the outside of one front tire to the outside of the other (if that makes any sense). My reason being is that I may be picking up a blaster this weekend I:I and am concerned about it fitting in...

Might be a dumb question, but what all does it do for you?

Has anyone here attached an analog speedometer to an ATV?