Recent content by BiGDawG

I didn't know when i bought the gaskets that they where junk seemed to have good reviews, but yea it's sitting till i get the leak tester in the mean time i'm going to take the tors out and the taillight wires may leave the headlight wires but i never really ride at night but who know when you...

yea there's a plug on the oil inject, i ordered the Athena P400485850205 Complete Engine Gasket Kit. I keep forgetting to unplug all the tors i want to just clean up the harness as i have no headlight or taillight. any idea where i can get the locking tab? i think it's a high output stator...

weird i wonder why that other boot was too small then and just realized both pics are from the same side lol though i got 1 from both sides

yea i won't ride anymore till i can but i don't have extra cash to buy a tester right now i got laid off a few weeks ago and luckily had some money stashed to pay for the rebuild here's the carb pictures

ah alright, maybe i'll take it back to the shop and see if he has a leak tester but i still don't know what to do with the air filter can you buy just the cage? i tried sitting every way possible and it just won't sit right. the reason it took it to the shop is i traded a r/c truck for the...

I can get a pic of the carb tomorrow, how would i go about measure the inside diameter of the engine? and i don't have the tools to leak test, seems like i would see oil leaking some where if it was leaking? motor is dry everywhere and yea i don't have that cage and the old filter was so...

well it didn't blow up.. but switching the plastics helped a bit, then i put the lid on and no more throttle issue, but it dose still shake pretty bad only at higher speeds so i checked all the tire's noticed the front rim's are pretty beat up and bent and i need rear bearings the air box lid...

getting ready to swap the plastics how do i leak test? and I'm missing that plastic cage, guess after i swap the plastics I'll go for another short ride and if i have the same issue I'll pull the carb and check the jetting and like i said i have no idea what the mods are it was in pieces when i...

hmm that might help it's weird how these filters are all foam filters i bought for my 350x and the tri-z had like a plastic lining on the inside to keep there form and so they would seal better but I'll switch to the other plastics tomorrow and see if i can get it to sit right on that 1, and...

yea we get in some deep water lol, not sure of the mods i know it has a custom extended swing arm and aftermarket a arms, motor wise no idea other then the full fmf pipe, I paid the local shop 200 bucks to put it back together with new seals and replace what needed to be. I did notice it would...

and i try to full throttle it it falls on its face but only in 4 5 and 6th gear other gears it has no issues.. i just got the blaster back from the shop i had got it in pieces traded some r/c stuff for it and the previous owner cut the air box all up there's 5 slits on each side and 1 in the...

cool thanks, yea i don't really care about the oil light i mainly want a key back cause i don't store the quad at home currently have no barn or garage as they made us tear them down.

there's not a wiring section so i figured i would post here, I have a 01 blaster that had the headlight removed and a custom 1 added, was there a key? if so can i add 1 again? i noticed there is a bunch of cut wire's near the seat and was there a neutral light or maybe an overheat light? i know...

hmm might just leave it for now then don't have the cash to ship it off and have it powder coated

I figure if i sand blast it then i can have my buddy who owns a body shop paint it for me, and cool i would of never knew they where aftermarket I noticed the front and rear bumper are custom and welded on so they can't be removed lol