So lemme start by saying I installed all my parts 2 day reeds went on no problem cleaned carb etc put pipe on uni filter drilled 6 holes and added uni vent caps. Only problem is it seems a little on the rich side I put the 260 jet in and needle clip on 5 I'm removing tors and oil injector this week as well but it won't idle now even when in turn the screw on top of tors so 2 moro I an gonna let out the air screw a quarter turn but there wad nothing in the directions about that lol guess is just fine tuning now.
I'm just hoping I didn't make a mistake putting the needle on 5 that was a pain in the a$$ !!! Lol its mainly after 1/2 throttle which should be the main jet right. And also to install my reeds I had to cut the rubber air flow thing flush correct??
I'm just hoping I didn't make a mistake putting the needle on 5 that was a pain in the a$$ !!! Lol its mainly after 1/2 throttle which should be the main jet right. And also to install my reeds I had to cut the rubber air flow thing flush correct??
Last edited: