Well I was putting my motor bsck in my quad when I noticed that there were needle bearings all over the inside of the swingarm where the motor/swingarm boly goes through the swingarm so I tore it apart and the bearings/bushings were completely destroyedc so I chiseled out what I could. I got my new bearings in the mail with no instructions and I couldnt tell what came from where. I know the bearings are on the outsides, but I have two sets of rubber bushings that I know go on the other side of the swinger but I dont know the order. The service manual shows the dust covers and all the washers and covers that go on the outside of the swingarm, but not the inside. Si im wondering if anyone has recently done one of these and remembers where the longer bushings went and where the shprter ones went.