Still sucking crankcase oil after seal replacement

[Skibo2385]

I got and 03 from guy its had been rebuilt recently his son left seat off and air box top off motor got full of water I guess water froze and push seal out on the clutch side so I replaced it it did fine for a few rides but all of them was no more 5 to 10 minutes ride I took it friends to it did find of about and hour then got smoke bad I mix my fuel so it not a oiler problem i told crankcase was seal with yamabond only when it was rebuilt. What should I be looking to do besides leak down test will do that soon

 

[Awk08]

could be the collar is leaking ....
[URL]https://www.blasterforum.com/threads/crank-collar-seal-vid.50433/[/URL]

or worse case the freezing of water in the bottom end broke the cases thru to the trans compartment

 

[Skibo2385]

That's it what I'm afraid of but after I put all the seal in on that side it did good till I got hot we rode for about a hour before it got to smoking I started yesterday it smoked but started to clear up some I'm hope it's just that collar

 

[Skibo2385]

The case gasket and crank seal is only places for the oil to leak in to piston side unless case is cracked correct