I saw blasterfreaks clutch cover and had to have it, so I ordered one off ebay and today me and my buddy hal cut out the hole on a cnc mill.
first we found the center and drilled a hole on a manual mill, then we indicated that hole on the cnc and wrote a program for a circle, we almost went a little to big, but it's going to work and it looks good.
Then hal machined the surface around the hole flat.
I dont know if I am going to leave those little tabs in the middle or not, they kinda look cool, but idk.
Tomorrow I will finish it hopefully and we're going to make some reed spacers also.
the scale down mill is so cool, it makes tiny parts super accurate
first we found the center and drilled a hole on a manual mill, then we indicated that hole on the cnc and wrote a program for a circle, we almost went a little to big, but it's going to work and it looks good.
Then hal machined the surface around the hole flat.
I dont know if I am going to leave those little tabs in the middle or not, they kinda look cool, but idk.
Tomorrow I will finish it hopefully and we're going to make some reed spacers also.
the scale down mill is so cool, it makes tiny parts super accurate
Last edited by a moderator: