Ok. Finally got the wiring figured out. and got it started. Could not get it to idle. moved the needle to #2 and can get it to idle but the screw is nearly bottomed out. But also i have no bottom end. it sputters thru 1st and 2nd and once you hit 3rd it slowly wakes up and goes. Just dont have the room to do a plug chop. I can only ride it in the ally. I need some help getting it closer so I can load it up and take it to the ride area.
3 mill
vito's big bore 72.5mm
v force reed cage and reeds
K&N with open airbox
Stock carb (working on a flat slide)
32.5 pilot
310 main
not sure if I need to drop the main to a 300 just to close up the needle size a bit. or move the clip to #1. or get a bigger pilot to feed the bigger displacement.
3 mill
vito's big bore 72.5mm
v force reed cage and reeds
K&N with open airbox
Stock carb (working on a flat slide)
32.5 pilot
310 main
not sure if I need to drop the main to a 300 just to close up the needle size a bit. or move the clip to #1. or get a bigger pilot to feed the bigger displacement.