so i removed the stock ignition coil on my banshee and replaced it with nology coils and now it seems to be misfiring in one cylinder. the right side pipe was blowing cold air and the pipe never got hot after running for like 10-15 min mean while the left pipe was nice and hot blowing hot air out the exhaust. i switched the coil leads and the problem followed. i didnt splice the wires but i added an adapter connector with two tabs on the coil and plugged the main lines into the one coil. i then jumped a wire from the adapter connector to the other coil. i did this for both the positive and negative and both adapters are on the same coil. could my problem be how i connected them? im thinking one is now getting more power than the other. do you think if i splice the wire with and even amount of wire it will work better? the bike starts one kick now and it was idleing fine until i switched the leads on the plugs, and then it started fine but didnt want to idle. should i have to readjust the idle after intalling these?