The instructions for my B1 pipe say to move the needle to the 3rd groove, where is the neede on the carb? I thoughtit was above the bowl but those screws are stripped, so what can I do?
Needle is in the slide. 2 small screws in there to remove.
They're stripped
well suck, might be looking for another slide. With a good screw driver, hold slide in one hand and lined ub as good as possible tap on driver as hard as possible. It will help loosen screws and maybe "renew" heads enough to get them out. Maybe throw a little heat on them from bottom side. Maybe long needle nose pliers?
Would think instructions would be calling to richen mid throttle
Stock is 2nd i believe
What if I just dont change it?