dont forget to upgrade your clutch duder. more power plus big tires equates bad for the stock clutch.
oh and i would suggest a banshee axle to widen it out some.
oh and i would suggest a banshee axle to widen it out some.
This is the meanest build I have seen in awhile! Major rep for the work you put into this. I would HIGHLY suggest beefing up the clutch and I can't say enough about the importance of suspension. Get some stiff shocks and a heavy clutch with strong springs with different gearing and you will have the meanest ride around. I would also suggest a large air scoop above the seat to throw even more air at the motor. Those seats block alot of air flow. After the suspension throw a 240 bbk, stroker crank, and a meaner pipe on that sucker and hold on tight 'cause it's gunna be wilder than any eight second ride! And I can also recommend that you NEVER EVER weld without an approved protection mask. I have had welders flash before and you DON'T want it. It is the most terrible thing I have ever experienced. It feels like someone lifts up your eyelid and dumps a mix of sand and salt in it and grinds it around. So please wear a mask or don't post pictures of you welding without a mask. That is your choice but don't influence the youngin's to do dumb stuff! Jeez....lol
. 1996BlasterBoy
Dang lol I would upgrade those to chromoly tie rods because it is almost impossible to bend but it looks like it was your bolt not your tie rod itself.
.yamaha28
nice job! I agree with what they said, throw some extra monies into it and you will have a crazy ride! I would love to see some donuts with that bad boy
.tertal
is it still kick start? and +1 for originality man lol.
.schmidtsandwich
props man, but youre crazy for cutting apart a perfectly good blaster, it looks fun, did you have to regear?