look at my head run it or mill it?

[kodie]

Hey pulled my top end and this is what my head looks like. What you guys think run it or have it milled?

This blaster is just a back up incase my banshee ever goes down. I only got a few hundred in the whole bike now and all it needs is bored and honed.

I've seen worse domes in a banshee. I think it is ok but not too sure.

 

[cruelsoul]

milling isn't much money go for it.

 

[blasterfreek30]

looks like a stocker to me..have it reshaped and milled, the stock head design on these are horrible from the factory

 

[mmajay]

If it was me i would glass bead blast it or soda blast it and run it. Dont waste your money on machineing it if you dont need too. Blasting it will make it clean as a whistle without removeing any alluminum. I done it many times with good results.

 

[scottabellinger]

id mill it too!