Anyone ever done any custom work to make it so you can replace the balljoints in the stock a-arms. Its REALLY hard for me to try and justify the cost for long travel ones, and to be honest, I dont really know if I want to widen my quad much, it comes in handy for transporting it, when its as skinny as it is sometimes.
Anyway, wondering if someone has cut the ends off and welded a solution on there that allows you to run the same balljoints as the aftermarket a-arms run.
I have a really hard time with the prices of these things. My balljoints are bad, and I have a hard time with the prices some of the ebay guys are asking for a-arms, and theres no guarantee the balljoints wont be trashed too.
Unless someone can turn me onto a ~200-250 dollar set of aftermarket a-arms.
Anyway, wondering if someone has cut the ends off and welded a solution on there that allows you to run the same balljoints as the aftermarket a-arms run.
I have a really hard time with the prices of these things. My balljoints are bad, and I have a hard time with the prices some of the ebay guys are asking for a-arms, and theres no guarantee the balljoints wont be trashed too.
Unless someone can turn me onto a ~200-250 dollar set of aftermarket a-arms.