Crank seal replacement help needed please and thank you

[Blastermit]

im replacing the right side clutch crank seals what is the best way to go about it? do i need to crack the case? a few buddies said id need to but i havent seen anyone talking about on any of the forums i looked up. but any help and suggestions to remove and put the new ones in is greatly suggested i tried looking on youtube but i couldnt find anyone doing it on a blaster the leak is coming from inside the clutch case smokes real bad its burning the trans oil i purchased tusk seals

 

[Larry's Shee]

Haven't seen anyone talking about it? This was covered just last week (again)

No need to split cases. 1 maybe two drywall screws, pop it out. Install with letters facing you. I pack the seals with grease and grease or oil shaft. If the right is bad, the left will soon leak too.
Use ONLY a blaster type flywheel puller.

https://www.blasterforum.com/threads/leak-down-test-video.57629/
https://www.blasterforum.com/threads/crank-collar-seal-vid.50433/

https://www.blasterforum.com/threads/smoking-like-crazy.72580/#post-820074

https://www.blasterforum.com/threads/left-crankcase-seal.72440/#post-820002


Don't be afraid to use the search function here, it works really well

https://www.blasterforum.com/search/16835701/?q=Crank+seals&o=date

But don't hesitate to ask questions, that's how we can learn