clutch problems

[fsteward]

hi guys as a few of you no ive been building my blaster for the last few months im at the point im nearly done my problem is im useing a ct sonic head ive put the bracket for the clutch cable on the head but now when i put it in gear and pull the cluch in i cant turn the rear wheels it just turns the engine over i no the cluch was good a few months ago when i took the engine out and ive not touched the bottom end apart from the timing any idears ive added a pic where u can see the bracket

 

[Herpderplol]

Clutch cable on the head? the bracket for it mounts on the jug bolt

Whats the problem? it wasnt clear to me..

so you let out the clutch and dont move?

 

[Blaaster]

It seems like the plates are not disengaging, is the cable pulling the lever far enough.

Could you take a close up of the cable and lever to see just where you fitted it.

 

[fsteward]

ill get some pics monday

 

[Awk08]

the CT cylinders rear acron nuts are accessed thru holes from above, not 2 exposed nuts like a stock cylinder.
they provide a seperate hole/bolt just for the clutch cable bracket.
is it possible it should have a CT supplied bracket instead of the stocker ?

maybe someone else with a CT will chime in....79bronco or dualstroke ?
or we'll wait for the pics.

got your cables slacked as far as it can at the clutch handle ?

 

[79 bronco]

I had to tweak the clutch cable bracket down a little to take some of the steep angle out, that made it smother.

Did you have any problems with the vent tube? Its a tight fit.

 

[79 bronco]

Your CT Sonic is going to want a better clutch kit and clutch basket!

 

[DUALSTROKE]

pm replied to.