Hey everyone. I recently rebuilt 2 blasters- one to upgrade and one to fix an air leak in the case. The first one I changed it out all new wiseco clutches and basket. 2nd one is all stock, didn’t change anything other transmission related, and it was all working properly. On both I left out the ball bearing at first not realizing it was in there for the rod, and I thought that was my issue on both bikes as to why the clutch wouldn’t work. But even with the ball bearings in them the clutch will not work on either bike. I seem to be having the exact same issue on both. I tried adjusting the rods and when the arrows are close/pointing to each other, the clutch rod basically becomes impossible to move forward from that point. On the bike with all new clutches the rod on the pressure plate ends up so far in that there’s hardly any thread left to put the nut back on, and the clutch still doesn’t work when it’s properly adjusted (as far as I can tell). No matter what I seem to do I can’t find a spot where the clutch actually does anything and it makes 0 sense to me, especially on the bike that I did not change anything on. Please help ASAP with any advice/info as I’m trying to take them both riding tomorrow for my little brothers birthday. Thanks as always