Ok so have a post in miss. Got lil figured out well replaced the clutch with kit now not getting any play in clutch it's not engaging or something.troubleshooting help
Are the two dots on the left side of the engine lined up like this, if not that's your problemBut yes replaced clutch n gasket. kickstart started acting ceased or feeling that way anyway wonce put back together and clutch level just waznt doing a thing for engaging gears
Thanks trying that now that's what couple other vids n ppl were saying let ya know shortlyAre the two dots on the left side of the engine lined up like this, if not that's your problem
Still no goThanks trying that now that's what couple other vids n ppl were saying let ya know shortly
If I'm missing the bb will that f*ck it all up n no did not replace rods prob only thing didn't do clutch seems OK but kick start seems to be binding or something feeling like that I'll check vids now n see if I did what's on them let ya know shortyAlso did you replace your push rods and the little bb looking ball bearing? If not that's probably your problem
ok this cover has a lil sliver missing it seems if u can see it would that affectIf I'm missing the bb will that f*ck it all up n no did not replace rods prob only thing didn't do clutch seems OK but kick start seems to be binding or something feeling like that I'll check vids now n see if I did what's on them let ya know shorty
Or sure tomorrow anew day I'll get back to y'allcheck for the ball bearing for sure. But also, the clutch doesnt move as much as you think! maybe like 1/4 IF THAT.
You definitely want to replace those rods! If they're worn or squished beyond the limit that will screw everything up and resulting in you having to split the cases sooner or later, I'll bet that you have the ball welded to one or both of the push rods. To replace the push rods drain the oil, take the clutch cover and pressure plate off, tip the quad on its side stator side facing up and the clutch cover facing down, make sure to tiurn your gas, then just take the stator cover off and use a rubber mallet and tap on the side housing for the clutch actuator. The vibrations should make the rods come out. If that doesn't work just use an electric sander without any sand paper on it and tape it around the clutch actuator with the vibrating side down, wait over night and it should have made the clutch rods out, but I don't think you'll need to do that, I used the rubber mallet, took about a half out but it was worth it.Or sure tomorrow anew day I'll get back to y'all