Hello All,
I recently rebuilt my lower end and took out the oil injection. The top end was bored 020. I have a spare Mikuni carb 36mm, it fits the boot and the reeds. I have it connected to a twist throttle and the travel of the flat side seems adequate.
I swapped the main jet from the original carb but I just want to make sure that it wont run too lean or cause another issue.
My only concern about using this is that it came off of an RM85 and since i'm not a carb expert, it just seems like there might be some side effects.
I still have the original carb, but it had been performing poorly even after a rebuild prior to the engine pull.
Any thoughts?
I recently rebuilt my lower end and took out the oil injection. The top end was bored 020. I have a spare Mikuni carb 36mm, it fits the boot and the reeds. I have it connected to a twist throttle and the travel of the flat side seems adequate.
I swapped the main jet from the original carb but I just want to make sure that it wont run too lean or cause another issue.
My only concern about using this is that it came off of an RM85 and since i'm not a carb expert, it just seems like there might be some side effects.
I still have the original carb, but it had been performing poorly even after a rebuild prior to the engine pull.
Any thoughts?