carb problems

[2strokebeater]

Alright guys thanks for all the help u have been giving me my blaster is runnin better than it ever did with all the help anyway I cleaned the carb today sprayed the jets and the lines but I noticed the tube that the pin is mounted on has a slot on it and its suppost to slide on the lip inside of the carb but mine is flush with the side so it doesn't stay in place it runs like that but I would like to kno how to make it right can u help me out. Thanks

 

[blasterdemon7]

I'm not realy sure what your talking about.Stock carb?

 

[2strokebeater]

Stock I think its called the slide it what the pin is screwed on with there's a notch on the slide then the cylinder of the carb is suppost to have a square peg to keep it aligned. I don't know if that helped any

 

[Surfrjag]

So the slide is able to turn?

 

[Larry's Shee]

Pin that keeps slide from spinning in slide bore? I had one come loos. Push it back in then re-stake the out side, you'll see where it was kind of "beat" over on outside.

 

[2strokebeater]

Is it a screw or should I just push on it

 

[blasterdemon7]

It's a press fit. See if you can push it all the way out . Clean the pin and hole then push it back in with some red loctite in the pin hole. Let sit overnight.

 

[jlsparky7]