Blaster seat staple size and misc

Discussion in 'Dress-up Parts' started by Blastermit, Mar 17, 2019.

  1. Blastermit

    Blastermit Member

    Joined:
    Mar 13, 2019
    Messages:
    28
    Likes Received:
    0
    Trophy Points:
    32
    Gender:
    Male
    what size staples do you use for a stock yamaha blaster seat and also i have a 89 blaser and from what ive heard the tors should have already been removed but it still there. recently i was trying to tune my bike so I decided to mess the idle screw on top of tors. i ended up stripping it and then it ran like crap it would high rev when started sometimes and right before it quit running on me i only had like 1/4 of my throttle power and could barely get out of neutral or switch gears just puting along. i want to get the tors elimination kit or just a whole new carb and throttle cable. anyways i unplugged the tors cable from the carb and from under the hood the one that ran to the thumb throttle was already unplugged. but it wont start plugged in or unplugged i see some people cut and cross there wires is that something i should try. from my understanding it should run with the tors cables unconnected. the plug is getting spark good compression solid reeds clean carb
     
  2. Tankbuster

    Tankbuster Member

    Joined:
    Oct 23, 2016
    Messages:
    112
    Likes Received:
    36
    Trophy Points:
    76
    Gender:
    Male
    Occupation:
    Machine Operator
    Location:
    Wi.
    I use standard T50 (3/8") staples and some spray adhesive when reupholstering seats.
     
    Blastermit likes this.

Share This Page