I'm getting ready to start my banshee project and need some input on the jetting. I'm working on porting another set of cylinders for it, but just want to ride it for now until the cylinders and head are done.
Its bone stock, but will be adding FMF fatty pipes and turbine core 2 silencers.
I'm trying to save time and want to get it in the ball park after adding the pipes.
Altitude...4,500 feet
Temperature... 80 degrees.
Carbs... stock mikuni VM26
Fuel ... 91 octane pump gas.
Leak tested engine and its good to go! no leaks. runs like a champ. The stock jets are 200.
Just want to add the pipes and silencers and re-jet. All the info I can find is for sea level, or a bit above sea level. I'm at 4,500 feet. I believe that for pipes, uni filter in the stock box WITH lid and no snorkel a good starting point would be maybe 300 mains? If in doubt, I'll start bigger and walk my way down. Just trying to save time by using your help. thanks in advance, Joe
Its bone stock, but will be adding FMF fatty pipes and turbine core 2 silencers.
I'm trying to save time and want to get it in the ball park after adding the pipes.
Altitude...4,500 feet
Temperature... 80 degrees.
Carbs... stock mikuni VM26
Fuel ... 91 octane pump gas.
Leak tested engine and its good to go! no leaks. runs like a champ. The stock jets are 200.
Just want to add the pipes and silencers and re-jet. All the info I can find is for sea level, or a bit above sea level. I'm at 4,500 feet. I believe that for pipes, uni filter in the stock box WITH lid and no snorkel a good starting point would be maybe 300 mains? If in doubt, I'll start bigger and walk my way down. Just trying to save time by using your help. thanks in advance, Joe