Search results

Hey @Awk08, my bike did not have a hose running from the clutch nipple, i added a short one and did the soap cup test.. no bubbles. I went over to the stator side, is the black stator cover is supposed to have an airtight seal? I do see there is 2 cutouts in the aluminum case that the cover...

Ok will try all that and get back to you. The reason i suspected a leak was because of irregular high idle, and it sometimes would take a while to idle down after a rev in gear.

Hey everybody, so i've been trying to do a leakdown test with AWK's leakdown tester. I have the expandable plug, cut with grease in the exhaust port. I have the tester in the intake I made sure piston was BDC Pumping the tester i cannot get a read above 1.5psi So I soap/water sprayed the...

Thanks for the advice! Not sure what i will go with yet. Mostly stock bike

Hello again. Ive got a few more questions now regarding my rigged exhaust. here is the starting setup again So now that ive unbolted the silencer and middle pipe. Ive noticed how loose my header is. Since ive got a large portion of the bike apart already i would like to fix this right. First...

Cleaner didnt work for me. However i did find that plunger in the link shown above. Will that work? Why doesnt it have the needle?

Also an answer on this please. Thanks again

Sorry i meant no lid, and what size pilot jet?

So my choke plunger also doesnt catch and stay open, any remedy for this? Otherwise will this work on the Vm26 (why is there no needle?) http://www.nichecycle.com/ncs/mikuni/parts-by-category/choke-assemblies-plungers/vm16-210a-choke-plunger-by-mikuni.html

Would this be ideal for my situation? https://toomey.com/catalog?olsPage=products%2Fb1-blaster-silencer-kit-chrome

1) what carb do you have??? mikuni vm 26mm 2) What type of aftermarket exhaust do you have? fmf fatty header (heatwrapped) & unbranded dirtbike silencer 3) What type of airfilter do you have? K&N 4) What kind of air box set up do you have?? No box 5) What size pilot jets are you using? Stock...

Ok i will check into tors tonight. Do i need all the blue hoses that come off the carb and just hang down by the rear arm?

Yep, there is 2 joints. Will look into getting correct parts. Thanks!

New atv owner here. Just bought a 2000 blaster. 1. Im unable to identify this mikuni. 2. I only see 'Made in Japan' 'Mikuni' and 'WO 13' on the carb. 3. Also whats with the blue hoses that were connected to nothing??? (I removed the fuel line b4 pic) 4. Finally im not seeing the rpm idle...

Hey everyone new atv owner here. Just bought this blaster and was curious about my best options here. As you can tell middle section 'rust colored' does not fully seat on either side. There is an exhaust leak where the muffler is pipe clamped on. Needing this fixed asap.