240 Top end and a couple carbs for sale

Wifesblaster

Wifesblaster

Built not bought
Feb 10, 2012
3,513
111
105
44
Maryland
Selling my 240 top end with a pump fuel head and a race fuel head, v force 4 reeds, reed spacer, and upp intake for 35mm-38mm carb. Stock cylinder with 240 LA sleeve pressed in it. Cylinder is ported by Ken oconnor and it is a trail port.

Top end has roughly 6 hours on it and is in perfect shape. $450 shipped for the cylinder, piston, both heads, vf4's, reed spacer, and intake. This top end was on my +4 stroker bottom end.

Carbs for sale - 36mm PWK quad vent and 38mm PWK. $90 each shipped without pilot, main, or needle jet. $115 shipped with jets of your choice.

Text me if interested. 443-829-9144. Thanks
 
The reason why I am selling my current top end is because I done believe it is capable to meet the demands of the custom dyno port pipe I had made. This cylinder ran good with off the shelf pipes. Woody's CT 240 motor seems to run pretty good so I am ordering the CT kit. Then it will be off to the blaster master for some doctoring.
 
Wait,:confused: This whole time you had a sleeved 240? I always thought you had the Ct 240...


Anyhow. Is the 240 cyl ported for the +4 crank or was a spacer used? Knowing you I am sure it was ported the correct way but just trying to clarify. I would also be interested in the v force reeds and possibly one or both of the heads if you decide to split things up.
 
38mm carb sold. 36mm carb is on hold. It is on hold because I made the buyer a deal. If he doesn't like the 38mm he can have the 36mm. I'm sure he will like it though. It was on the same setup as mine.

Thanks Mark. On its way out to ya tomorrow. Good talking to ya
 
Installed and idling beautifully. I have not been able to do a plug chop yet, my street is not long enough. I'll have to take it somewhere to do that. Thanks for the assistance in getting things situated. I'm amazed at how crisp the throttle is compared to the 34mm that was on it.
 
  • Like
Reactions: jus_me
mlrblaster said:
Installed and idling beautifully. I have not been able to do a plug chop yet, my street is not long enough. I'll have to take it somewhere to do that. Thanks for the assistance in getting things situated. I'm amazed at how crisp the throttle is compared to the 34mm that was on it.
Click to expand...

Glad to hear you like it. Welcome to the 38mm family lol
 
You must log in or register to reply here.

Similar threads

G
input and opinions on a new blaster exhoust for sale
Replies
0
Views
196
Custom Fabbing
Gm3
G
crusty4365
DT200 Swap
Replies
1
Views
536
Engine Mods and Swaps
Jess brown
J
TrailRider
Blaster runs for a couple seconds then bogs and dies
Replies
11
Views
2K
Engine
Tooloose
Tooloose
L
First full rebuild
Replies
10
Views
1K
Full Rebuilds
LJulian80
L
gsustaitav19822
03+ brake system for sale
Replies
14
Views
2K
For Sale
BlasterMarc
B
Top Bottom
Back