Recent content by sportnitro

sorry it took some time to get back you can extend the hose back down the frame rail but keep it up by the bars then drop towards ground this way the oil would have to go that high before it leaks. watch what kind of oil you are using in the crankcase and always use the recommended stuff...

I noticed you have not donated to sell either.sure you sponser a forum but no gold bars underneath your avatar:D

did you set up the nut and set screw on the clutch cover The best thing to do is loosen the nut screw the screw out until there is no pressure felt on scew then bring it up to where the pressure starts to hit the screw back out 1/8 turn.tighten jam nut If you have some use a little blue locktite...

you probably have a little varnish in the needle and seat ,it is easy to remove the carb and pull the 4 screws out of the bottom tap the bowl to remove and get yourself some gum out and spray her down.while you are there check your pilot jet and main jet for any gum build up.I have found the...

just remember on your air cooled engine get it good and hot then run it across a alot of water it will cold seize on you a good 90% of the time.If it quits and you go to start it and seems a little tight but then starts and runs you have already scored your piston