Recent content by 240Fun

i did a leak down already and it held overnight at 6 psi i was gonna if needed but i think it's ok for now maybe when i do a top end on it but for now it's ok what i need now is a nice exhaust but it's hard when your trying to have fun on a budget

So a while ago i picked up a completely stock blaster for my kids to run around the yard and one day i'm watching my step daughter ride around and all of a sudden it started to rev up (air leak starting) higher and higher and i knew something was failing sure enough the exhaust was leaking a...

Leak down test is a definite need to do after a rebuild even if everything is new the intake boot on my quad took me 2 tries to get it sealed up right

So I will say this when started my Blaster build I had everyone tell me go with a big bore gotta get the big bore, so I bought it but when I talked with KOR to build the motor he told me with the stock crank you would of been better off with the stock piston. I run it in trails I'm 300lbs and...

sold

I'm near buffalo NY

i have a DT200 with the original wiring harness off the bike i bought it off someone on here a while ago and never got around to doing anything with it i was told it ran when i got it looking to get 750 for it i would like to sell it local but i can ship it within the U.S.

Back when I put my blaster together I got the ASR LT arms and the heim joints at the time and the same thing kept on happening i went thru like 3 or 4 full sets then switched out to ball joints finally and gave up on the heim joints i'd be interested to hear how the new ones work out

hey how about a rear grab bar?

i got the ASR arms and like them but only after i switched to the sealed ball joints and banshee spindles

got me curious now i got a +4 swinger from them i'll be sure to give it a good once over when i pull it out in the spring for sure after seeing this

when i put mine together i had a bad airleak around the intake boot going to the reeds someone had over torqued the crap outta my boot i ended up using silicone to get a good seal watch those youtube videos and make up a leak tester worth every penny unless you like doing engine rebuilds

i got some plastic mud guards to try and extend the front and rear fenders it looks like it should work unfortunately i wont get to do it until next spring I like my blaster but getting sick of looking like mud man and getting blasted in the face from the front tires on my quad

doing the KOR head mod and a pipe will do more than going to max over bore for sure

i have an 89 engine in a 2004 frame no issues at all the stator wiring is different but you can swap the stator out to work with your wiring on the frame as far as looking out for things cracks in the engine cases around the crank shaft and where the chain goes around the drive sprocket