rear skid diy

[kep3vin]

dont know it this has been done just started today will update with progress.
little bit thicker metal. not rusted and nasty, and no spaces on the ends
let me no wat u think

removed on cut welds

measure cut bend(still need to round it)

nice fit

trim, weld, other side, sand paint

 

[Caterpillarmech]

I like it. Iam currently building braces for my frame. I'll do this too while she is down.

 

[kep3vin]

update trimmed & welded

2 coats paint on 2 more coats tomorrow pics up when its done

 

[kep3vin]

ALL DONE!!!!

 

[yb200]

nice work .

 

[super noober]

great work man, have some rep I:I

 

[blasterdemon7]

Nice job...........................I:I

 

[Uuhnt]

Nice job man, it looks great.

 

[brandoz28]

looks good man .

 

[trevorman210]

that will work good

 

[DUALSTROKE]

Nice job.Nice way to make the stocker stronger and better.

 

[kep3vin]

rode today in the floods here got a nice branch stuck in the middle pissed me off, time to add a middle stay tuned...

 

[brandoz28]

after adding the center that thing will look a lot like the aftermarket units

 

[blasterfreek30]

great work bud...looks alot better than the stock plates

 

[slickerthanyou]

Looks good dude! I plan on making one out of stock myself!

 

[kep3vin]

here you go

did 2 coats of primer this time and used grey rim enamel paint
same processe cut metal to size bend hold on with vise grips and tack weld way.. its deff 2x as heavey but its wayy strong... also put in a few drain holes dont for get those had a puddle in there after 1st ride

 

[slickerthanyou]

Cool !

 

[kep3vin]

works well we have alot of down trees from the past storm my lil bro went over a few u can see the 2 scrathes

 

[matt75]

Looks good bro... Would drilling some holes in the bottom plates be a good idea? To drain water, dirt, mud and what not.... Looks pretty heavy duty... good job!

 

[98blaster+4]

hey that looks sweet,while your at it you should extend the bottom all the way up the swingarm to where it meets the frame.