fresh motor build following ken oconner vids!

[blaster0187]

Here she is
Hot rods crank kit new bearings
New snap rings washers etc
greased and loctite on all seals
150 psi compression
Boyesen pro series reeds
Fired right up and sounds awesome
Waitin on front hub bearings and steering stem b4 the test run!

Thanks mr oconner for all the vids he knos his sh*t 4 sure

 

[Blaaster]

Do not forget the leak test, heat cycles, re tension and break in proceedure.

What did you mean by Loctite on all seals?

 

[Awk08]

nice work bro !

 

[blaster0187]

Yes did break in procedure....loctite around the outside of seals for assurance per oconner

 

[Larry's Shee]

Seems like only yesterday you came around with all kinds of questions 8-|

Now you're a semi-pro BLASTER MASTER I:I

Good Job !!Green Gladly Given!! I:I

 

[blaster0187]

Yea I know....a lot of questions but I got it down ....very simple when proper tools and oconner vids
Are used!all the litle stuff I seen I tried all seems well just rode around the yard feels nice very smooth and sooo quiet its awesome! 1st one I've split cases on