Seen many people on here asking hwo to paint there rims and do it the right way here is a step by step tutorial of how to do so.
SUPPLIES NEEDED
Step one Remove your tires off of your atv.
Step two take tires and sand them down using 60 - 220 grit sandpaper removing any rust or blemishes for the best results.
BE SURE TO REMOVE ANYTHING LIKE THIS
Step three after removing all rust and blemishes take your denatured alcohol and wipe down the rims removing any dust/ dirt your rims should now look like this
Step four using masking tape tape your way around the rim then take newspaper or shop towels as seen in my pictures and stick them to the tape folding them over to cover any spots you might not want to spray
step five take your rim color and then spray a light coat of it on. when its done drying usually within a half hour you can put on a second coat. repeat this step 3 to 4 times or untill rim is covered to your satisfaction ( sanding may be needed between coats)
Step six if sanding is need do so next take your clear and spary a light coat on the rims repeat this step 6 to 7 times to ensure no chipping with hard ridding
Step seven remove paper from around tires ( wait at least 12 hours till all paint is fully dry)and then bolt them on and your ready to go your finished product should look like this
SUPPLIES NEEDED
Step one Remove your tires off of your atv.
Step two take tires and sand them down using 60 - 220 grit sandpaper removing any rust or blemishes for the best results.
BE SURE TO REMOVE ANYTHING LIKE THIS
Step three after removing all rust and blemishes take your denatured alcohol and wipe down the rims removing any dust/ dirt your rims should now look like this
Step four using masking tape tape your way around the rim then take newspaper or shop towels as seen in my pictures and stick them to the tape folding them over to cover any spots you might not want to spray
step five take your rim color and then spray a light coat of it on. when its done drying usually within a half hour you can put on a second coat. repeat this step 3 to 4 times or untill rim is covered to your satisfaction ( sanding may be needed between coats)
Step six if sanding is need do so next take your clear and spary a light coat on the rims repeat this step 6 to 7 times to ensure no chipping with hard ridding
Step seven remove paper from around tires ( wait at least 12 hours till all paint is fully dry)and then bolt them on and your ready to go your finished product should look like this