Chinese carburetor

[Tonyv913]

I Baught a carburetor from eBay and I want to know how to get it to idle normal with my mods. Also what jets come in them stock?
If I need to change my pilot or main jet, let me know. My altitude is Pennsylvania!

I'm running a toomey b1 with the airbox lid on.
Thanks

 

[Tooloose]

I Baught a carburetor from eBay and I want to know how to get it to idle normal with my mods. Also what jets come in them stock?
If I need to change my pilot or main jet, let me know. My altitude is Pennsylvania!

I'm running a toomey b1 with the airbox lid on.
Thanks

Is it a stock blaster carb?

 

[Tonyv913]

Is it a stock blaster carb?

I'm pretty sure it's Chinese, but I still have my old carb but it's dirty as hell, so I didn't put it on.

 

[Tonyv913]

Also when I pull the choke out the quad stalls.

 

[Tonyv913]

Is it a stock blaster carb?

It only has a bad idle when I rev it up, but once I put it in gear and let the clutch out some it goes away.

 

[Tooloose]

It only has a bad idle when I rev it up, but once I put it in gear and let the clutch out some it goes away.

??? I don't understand

 

[Tooloose]

What goes away?

 

[Tonyv913]

??? I don't understand

The banging idle it has.

 

[Tooloose]

Is the engine knocking ?

 

[Tonyv913]

Is the engine knocking ?

Nope.

 

[Blaaster]

Idle adjusting.
Set float level, make sure that all jets are clean and fuel flows freely from the float bowl drain
when the screw is cracked open.
Start with air screw 1.5 turns out.
Warm up motor and then set idle screw for a faster idle, 2000rpm+
Adjust air screw either way to get the fastest idle.
Adjust air screw a little at a time leaving 10 secs or until the motor responds.
Re adjust idle screw for desired idle .
if the air screw ends up being more than 2 1/2 turns out the pi;]lot is too big.
if the air screw is less than 1/2 a turn out the pilot is too small