Recent content by Dtrap

I made sure the TORS was unhooked and it was. I still have the same problem with it stalling as soon as I touch the gas. Any more advice from any one. I am not really sure what to check next. What else could cause this problem? Thanks for the advice so far.

Need some help guys, We were out riding the other day and my brothers blaster just died. We were ridding along and it just sounded like it ran out of gas and rolled to a stop. It will start very easily and idle ok but as soon as I touch the gas it dies. I cleaned the carb and it looked fine...

Going from a 220 or 230 to a 290 is a big jump. I would try the 250-270 like mentioned above. To need a 290 you would have to have more mods than you do.

Whats up guys, just bored waiting for everything to dry out around here and was wondering if the blasters can really keep up with the modded bigger 4pokes out there and if so what mods would be necessary to get there. Do you need to put like 5000.00 in extras into it? Even after doing all that...

Well I think I found a deal on a 35mm pwk but if you guys think I should only go 34mm let me know. As far as the 240 kit that will probably be a 3-4months at least.

I can afford a few hundred right now but would be willing to save up a little longer if there is something better for a few more dollars.

Whats up guys, Just bought a spare motor to put in the blaster and was looking for new carb sugguestions to match the new motor. It is stock bore with a +4mm stroker crank and ported and polished head. I also have a full platium pro circuit exhaust I will be putting on it as well as a k&n...

Yea I will be getting a bigger carb by the end of Feb. but want to ride before then and a few jetts arnt to much to hold me over till then. I guess I will start lower and work my way up. Thanks so far guys. What carb do you guys reccomend going with

Thanks for the guess

I picked up a new motor the other day that I want to install on the blaster and still run the factory carb for now. The motor has a +.4 mil crank and a trail port and ploish on it already. I also have a full pro circuit exhaust I will be putting on and a k&n air filter. My question is the stock...

Which oil do you reccomend? I just bought a couple bottles of Spectro Platinum SX2 last week.

The gas is has been in the tank for about 20 days so I will try that and the mix is 32:1. I will get a new plug and check the reeds and clean the carb and see what happens from there. Thanks for the advice and prompt reply. I did let it warm up but only for a few minutes.

Whats up guys Ive got a problem. Just bought this blaster a few weeks ago and took it out and it sounds funny to me especially at low RPMs. When I get it going it is now starting to die after 30 seconds or so. Here is a sound clip from when I tried to run it today. Any help from you pros would...

Thanks wildcard I researched a few but they were closed today. I wasnt sure if that would be a good way to go or not. I will give a few a call tomorrow and see what is up.

Can anyone reccomend a good shop around Indianapolis IN who can take care of boring my cylinder. I am willing to ship it out if I have to but I am looking for something quick as I have a trip planed in a few weeks and need it back in time to break it in before leaving. Any advice would be great...